InitSDeclMgr

Initialize the Slot Manager

#include <Slots.h> Slot Manager

SpBlockPtr spBlkPtr ; address of 56-byte Slot Parameter Block

structure

returns Error Code; 0=no error

InitSDeclMgr initializes the Slot Manager. Used only by the Operating

System.

spBlkPtr is the address of a 56-byte Slot Parameter Block structure.

Returns: an operating system Error Code. It will be one of:

noErr (0) No error

smEmptySlot (-300) No card in slot.

smCRCFail (-301) CRC check failed.

smFormatErr (-302) FHeader format is not Apple's

smRevisionErr (-303) The revision of the card's declaration ROM is wrong.

smNoDir (-304) Directory offset is NIL

smNosInfoArray (-306) The SDM could not allocate memory for the sInfo

array.

smResrvErr (-307) A reserved field of the declaration ROM was used.

smUnExBusErr (-308) An unexpected bus error occurred.

smBLFieldBad (-309) A valid ByteLanes field was not found.

smDisposePErr (-312) An error occurred during execution of DisposPointer.

smNoBoardSRsrc (-313) There is no board sResource.

smGetPRErr (-314) Error during execution of sGetPRAMRec.

smNoBoardId (-315) There is no board ID.

smInitStatVErr (-316) The InitStatus_V field was negative after Primary or

Secondary Init.

smInitTblVErr (-317) Error while trying to initialize the sResource Table.

smNoJmpTbl (-318) Slot Manager jump table could not be created

smBadBoardId (-319) Board ID was wrong; reinit the PRAM record

Notes: The contents of the parameter block are un defined. This procedure

allocates the sInfo array and checks each slot for a card. If a card is not

present, an error is logged in the initStatusA field of the SInfoRecord for

that slot; otherwise the card's firmware is validated, and the resulting data

is placed in the slot's SInfoRecord.

Referenced by (3):